. MAINTENANCE SERVICE PROCEDURE MAINTENANCE SERVICE PROCEDURE any other 4 - 66 6. Loosen n ut (7), t hen remove co ne washer (8), turbin e cas e (9), filter elem ent (10), and O-ring (11) from rotor turbin e (12 7. Clean all parts a nd the seal su rface with a clean cl 8. Check th at ther e is no damag e to the nozzle portio Check al parts. Replace any parts which are c racked or damaged. NOTICE When i nstallin g rotor turbine (12), mak e sure that roll p in (A) in the rotor turbine shaft i s aligne d with slot (B) in the rotor turbine base. Failure to align them c ould cause dam age to the turbine 9. Replace O-ring (11), then insta ll new filter element (1 0) to rotor turbine (1 10.
Install tur turbine (1 2). Tighten nut (7) fu NOTICE Tighten nut (7) by han d. Do not tighte n it with a wrench