116 UENR4490-01 Basic Engine If the piston pin bearing requires replacement but the original connecting rod is not replaced, the following procedures must be performed: 3. Check the front camshaft bearing for wear. Refer to Specifications, “Camshaft Bearings” for the correct specification of the camshaft bearing. If a new bearing is needed, use a suitable adapter to press the bearing out of the bore. Ensure that the oil hole in the new bearing faces the front of the block. The oil hole in the bearing must be aligned with the oil hole in the cylinder block. The bearing must be aligned with the face of the recess. 1. Determine the grade of length of the connecting rod.
Use one of the following characteristics: The mark The color Measuring the length i03907820 Cylinder Head - Inspect 2. Remove the piston pin bearing from the connecting rod. Install a new bearing in the connecting rod. The new bearing is partially finished. The new bearing must be bored off- center to the correct diameter. This off-center position is determined by the grade of length of the connecting rod. Refer to table 12 . The correct diameter of the bore in the piston pin bearing is given in Specifications, “Connecting Rod”. 1. Remove the cylinder head from the engine. 2. Remove the water temperature regulator housing. 3. Inspect the cylinder head for signs of gas or coolant leakage.
Surface finish of the bored hole in the piston pin bearing . . . . . . . . . . . . . . . . . . . . . Ra 0.8 micrometers 4. Remove the valve springs and valves. 3. Machine the ends of the piston pin bearing to the correct length. Remove any sharp edges. Refer to Specifications, “Connecting Rod”. 5. Clean the bottom face of the cylinder head thoroughly. Clean the coolant passages and the lubricating oil passages. Make sure that the contact surfaces of the cylinder head and the cylinder block are clean, smooth, and flat. Table 12 references the following information: Grade of letter of the connecting rod, the color code of the connecting rod and the length of the connecting rod. 6.
Inspect the bottom face of the cylinder head for pitting, corrosion, and cracks. Inspect the area around the valve seat inserts and the holes for the fuel injection nozzles carefully. Table 12 7. Test the cylinder head for leaks at a pressure of 200 kPa (29 psi). i05391913 Cylinder Block - Inspect 1. Clean all of the coolant passages and the oil passages. 2. Check the cylinder block for cracks and damage. Length Grades for Connecting Rods Grade Letter Color Code Length Of The Connect- ing Rod (CRL) B Blue 163.081 to 163.114 mm (6.42050 to 6.42180 inch)