UENR4490-01 117 Basic Engine Note: The dimension of the valve seats to the flame face must be corrected after resurfacing the cylinder head. Refer to Specifications, “Cylinder Head” for the correct dimensions for the valve seats. i04156372 Piston Height - Inspect Table 13 If the height of the piston above the cylinder block is not within the tolerance that is given in Specifications, “Piston and Rings”, the bearing for the piston pin must be checked. Refer to Systems Operation, Testing and Adjusting, “Connecting Rod - Inspect”. If any of the following components are replaced or remachined, the piston height above the cylinder block must be measured:
Illustration 110 g02148937 Flatness of the cylinder head (typical example) (A) Side to side (B) End to end (C) Diagonal 8. Measure the cylinder head for flatness. Use a straight edge and a feeler gauge to check the cylinder head for flatness. Crankshaft Cylinder head Measure the cylinder head from one side to the opposite side (A). Connecting rod Measure the cylinder head from one end to the opposite end (B). Bearing for the piston pin The correct piston height must be maintained in order to ensure that the engine conforms to the standards for emissions. Measure the cylinder head from one corner to the opposite corner (C).
Refer to Specifications, “Cylinder Head” for the requirements of flatness. Note: The top of the piston should not be machined. If the original piston is installed, be sure that the original piston is assembled to the correct connecting rod and installed in the original cylinder. Resurfacing the Cylinder Head The bottom face of cylinder head can be resurfaced if any of the following conditions exist: The bottom face of the cylinder head is not flat within the specifications. The bottom face of the cylinder head is damaged by pitting, corrosion, or wear. Note: The thickness of the cylinder head must not be less than 150.8 mm (5.93700 inch) after the cylinder head has been machined.
Required Tools Tool Part Number Part Description Qty A 21825617 Dial Gauge 1 B 21825496 Dial gauge holder 1