118 UENR4490-01 Basic Engine 3. Position Tooling (B) and Tooling (A) in order to measure the piston height above the cylinder block. The piston height should be measured at positions (X) or (Y). Slowly rotate the crankshaft in order to determine when the piston is at the highest position. Record this dimension. Compare this dimension with the dimensions that are given in Specifications, “Piston and Rings”. i03635082 Flywheel - Inspect Table 14 Illustration 111 g01201898 Typical example Alignment of the Flywheel Face Illustration 112 g02351060 Typical example Illustration 113 g01332565 Typical example 1.
Use Tooling (A) and Tooling (B) in order to measure the piston height above the cylinder block. Use the cylinder block face to zero Tooling (A). 1. Install Tooling (A) in illustration 113 , as shown. 2. Set the pointer of the dial indicator to 0 mm (0 inch). 2. Rotate the crankshaft until the piston is at the approximate top center. 3. Turn the flywheel. Read the dial indicator for every 45 degrees. Note: During the check, keep the crankshaft pressed toward the front of the engine in order to remove any end play. Required Tools Tool Part Number Part Description Qty A 21825617 Dial Indicator Group 1