UENR4490-01 75 Engine Operation Engine Speed/Timing Sensor – An engine speed/ timing sensor is a hall effect switch that provides a digital signal to the ECM. The ECM interprets this signal as the crankshaft position and the engine speed. Two sensors are used to provide the speed and timing signals to the ECM. The primary sensor is associated with the crankshaft and the secondary sensor is associated with the camshaft. Diesel Particulate Filter – The Diesel Particulate Filter filters particulates from the exhaust gases. The hot exhaust gases burn off the particulates. This process prevents the DPF from becoming blocked with soot.
Digital Sensor Return – The common line (ground) from the ECM is used as ground for the digital sensors. Estimated Dynamic Timing – Estimated dynamic timing is the estimate of the actual injection timing that is calculated by the ECM. Digital Sensors – Digital sensors produce a pulse width modulated signal. Digital sensors are supplied with power from the ECM. Event Code – An event code may be activated in order to indicate an abnormal engine operating condition. These codes usually indicate a mechanical problem instead of an electrical system problem. Digital Sensor Supply – The power supply for the digital sensors is provided by the ECM.
Exhaust Back Pressure Regulator – The exhaust back pressure regulator regulates the gas pressure in the exhaust system. The valve can restrict the flow of exhaust gases in order to increase the exhaust back pressure. An increase in exhaust back pressure will increase the temperature of the exhaust gases. The increase in temperature will improve the process that burns off the soot in the DPF. Direct Current (DC) – Direct current is the type of current that flows consistently in only one direction. Dosing Control Unit (DCU) – The DCU controls the injection of Diesel Exhaust Fluid (DEF) into the exhaust gas stream.
DT, DT Connector, or Deutsch DT – This is a type of connector that is used on this engine. The connectors are manufactured by Deutsch . Diagnostic Lamp – A diagnostic lamp is sometimes called the check engine lamp. The diagnostic lamp is used to warn the operator of the presence of an active diagnostic code. The lamp may not be included in all applications. Duty Cycle – See Pulse Width Modulation . Diesel Exhaust Fluid (DEF) – DEF is a mixture of urea and water that is injected into the exhaust stream. The heat in the exhaust gas releases the ammonia in the DEF. The ammonia reacts with the oxides of nitrogen (NOx) in the SCR filter to produce nitrogen and water vapor.
Electronic Engine Control – The electronic engine control is a complete electronic system. The electronic engine control monitors the engine operation under all conditions. The electronic engine control also controls the engine operation under all conditions. Electronic Control Module (ECM) – The ECM is the control computer of the engine. The ECM provides power to the electronics. The ECM monitors data that is input from the sensors of the engine. The ECM acts as a governor in order to control the speed and the power of the engine. Diesel Oxidation Catalyst – The DOC is a device in the exhaust system that oxidizes certain elements in the exhaust gases.
These elements can include carbon monoxide (CO), hydrocarbons and the soluble organic fractions (SOF) of particulate matter. Diesel Particulate Filter – The Diesel Particulate Filter filters particulates from the exhaust gases. The hot exhaust gases burn off the particulates. This process prevents the DPF from becoming blocked with soot. Electronic Service Tool – The electronic service tool is used for diagnosing various electronic controls and the electronic service tool is also used for programming various electronic controls. Digital Sensor Return – The common line (ground) from the ECM is used as ground for the digital sensors.
Engine Monitoring – Engine Monitoring is the part of the electronic engine control that monitors the sensors. This also warns the operator of detected problems. Digital Sensors – Digital sensors produce a pulse width modulated signal. Digital sensors are supplied with power from the ECM. Digital Sensor Supply – The power supply for the digital sensors is provided by the ECM. Engine Oil Pressure Sensor – The engine oil pressure sensor measures engine oil pressure. The sensor sends an electronic signal to the ECM that is dependent on the engine oil pressure. Direct Current (DC) – Direct current is the type of current that flows consistently in only one direction.