Perkins — Perkins 1204F-E44TA and 1204F-E44TTA Industrial Engine Systems Operation Manual

UENR4490-01 95 Air Inlet and Exhaust System cooling system or the engine. Refer the service manual in order to check for leakage. If the exhaust gas cooler (NRS) does leak, the exhaust gas cooler (NRS) should be replaced. A compression test should not be the only method which is used to determine the condition of an engine. Other tests should also be conducted in order to determine if the adjustment or the replacement of components is required. 2. Follow steps 2.a to 2.i in order to test the gas side of the exhaust gas cooler (NRS). Before the performance of the compression test, make sure that the following conditions exist: a. Plug the gas inlet (5) of the exhaust gas cooler (NRS) (3).

The battery is in good condition. b. Plug the gas outlet port (1) with tube and pressure regulator assembly. The battery is fully charged. The starting motor operates correctly. c. Make sure that the air pressure regulator is closed and connect compressed air to the pressure regulator. The valve lash is correct. All glow plugs are removed. d. Use a suitable pressure gauge in order to apply an air pressure of 250 kPa (36 psi) to the exhaust gas cooler (NRS). The ECM is powered. The fuel pressure sensor is connected. e. While the exhaust gas cooler (NRS) is still pressurized, submerge the cooler in water that is at ambient temperature. The suction control valve is connected. f.

Allow the exhaust gas cooler (NRS) to settle in order for the air that is trapped to escape. g. Observe the exhaust gas cooler (NRS) for air bubbles that indicate a leak. If air bubbles are seen within 3 minutes, this indicates a leak with the exhaust gas cooler (NRS). Note the location or the origin of the leak. Record this information. h. If no bubbles are detected after 3 minutes, the exhaust gas cooler (NRS) is reusable. i. Remove the exhaust gas cooler (NRS) from the water. If the exhaust gas cooler (NRS) does not leak, the problem may be elsewhere in the cooling system or the engine. Refer the service manual in order to check for leakage.

If the exhaust gas cooler (NRS) does leak, the exhaust gas cooler (NRS) should be replaced. Illustration 83 g01925436 Typical example i04027325 Compression - Test 1. Remove the glow plug (1). Refer to Disassembly and Assembly, “Glow Plugs - Remove and Install” for the correct procedure. 2. Install a suitable gauge for measuring the cylinder compression in the hole for the glow plug. The cylinder compression test should only be used in order to compare the cylinders of an engine. If one or more cylinders vary by more than 350 kPa (51 psi), the cylinder and related components may need to be repaired. 3. Remove the fuse for the glow plugs. 4.

Operate the starting motor in order to turn the engine. Record the maximum pressure which is indicated on the compression gauge. 5. Repeat steps 2 and 4 for all cylinders.