Perkins — Perkins 1204F-E44TA and 1204F-E44TTA Industrial Engine Systems Operation Manual

Air Inlet and Exhaust System 96 UENR4490-01 6. Install the fuse for the glow plugs. Bent pushrods i04319692 Engine Valve Lash - Inspect Broken socket on the upper end of a pushrod Loose adjustment screw for the valve lash Issues with the hydraulic lifters Table 6 If the camshaft and valve lifters show rapid wear, look for fuel in the lubrication oil or dirty lubrication oil as a possible cause. Valve Lash Check Accidental engine starting can cause injury or death to personnel. (1) The Crankshaft Turning Tool is used on the front pulley. (2) This Tool is used in the aperture for the electric starting motor.

To prevent accidental engine starting, turn the ignition switch to the OFF position and place a do not operate tag at the ignition switch location. 1. Remove the valve mechanism cover. Refer to Disassembly and Assembly, “Valve Mechanism Cover - Remove and Install” for the correct procedure. Illustration 84 g01335181 Cylinder and valve location (A) Exhaust valve (B) Inlet valve Too much valve lash can cause some broken valve stems, springs, and spring retainers. Damage to the valve mechanism will produce emissions in excess of the correct specification. Illustration 85 g01958182 Typical example The hydraulic lifter will compensate for all normal wear of the components of the valve train. 2.

Remove the plug (1) from the cylinder block. Use Tooling (A) to rotate the crankshaft until the number one piston is at the top center position. Too much valve lash can be an indication of the following problems: Note: The number one piston may be on the compression stroke or the exhaust stroke. Worn camshaft and valve lifters Worn rocker arms Required Tools Tool Part Number Part Description Qty A(1) 21825576 Crankshaft Turning Tool 1 A(2) 27610291 Barring Device Housing 1 27610289 Gear 1 B T400014 Timing Pin (Crankshaft) 1