Perkins — Perkins 1204F-E44TA and 1204F-E44TTA Industrial Engine Systems Operation Manual

UENR4490-01 97 Air Inlet and Exhaust System 3. Install Tooling (B) into the hole (X) in the cylinder block. Use Tooling (B) in order to locate the crankshaft in the correct position. 8. If there is an engine valve lash at any position the engine valve lash may be caused by a normal leakdown of the hydraulic lifter. Push the affected rocker arm (1) against the pushrod. Monitor the rocker arm (1) for movement. The rocker arm (1) should rotate as the pushrod is pushed up by the recovery of the hydraulic lifter. Once all motion has ceased test again for an engine valve lash. There should be no engine valve lash. Note: Do not use excessive force to install Tooling (B).

Do not use Tooling (B) to hold the crankshaft during repairs. 4. Check the rocker arms for an engine valve lash. There should be no engine valve lash. 9. If an engine valve lash is found in any position, examine the valve mechanism components for excessive wear or damage. This includes the hydraulic lifters. i04215789 Valve Depth - Inspect Table 7 Illustration 86 g02333215 Typical example One electronic unit injector is not shown for clarity. 5. If there is an engine valve lash at any position the engine valve lash may be caused by a normal leakdown of the hydraulic lifter. Push the affected rocker arm (1) against the pushrod.

The rocker arm (1) should rotate as the pushrod is pushed up by the recovery of the hydraulic lifter. Once all motion has ceased test again for an engine valve lash. There should be no engine valve lash. 6. Remove Tooling (B) from the crankshaft. Use Tooling (A) to rotate the crankshaft in a clockwise direction. The crankshaft should be rotated 360 degrees. Install Tooling (B) to the crankshaft. 7. Check the rocker arms for an engine valve lash. There should be no engine valve lash. Illustration 87 g01201916 Typical example Required Tools Tool Part Number Part Description Qty A 21825617 Dial gauge 1 B 21825496 Dial gauge holder 1