Perkins — Perkins 1204F-E44TA and 1204F-E44TTA Industrial Engine Systems Operation Manual

Air Inlet and Exhaust System 98 UENR4490-01 1. Ensure that the face of the valves are clean. Ensure that the bottom face of the cylinder head is clean. Ensure that the cylinder head is not distorted. Refer to Systems Operation, Testing and Adjusting, “Cylinder Head - Inspect” for the procedure to measure flatness of the cylinder head. 2. Use the Tooling (A) to check the depths of the inlet valves and the exhaust valves below the face of the cylinder head. Use Tooling (B) to zero Tooling (A). 3. For the minimum and maximum limits for a new engine for the inlet valves and the exhaust valves, refer to Specifications, “Cylinder Head”. 4.

Service wear occurs on an engine which has been in operation. If the valve depth below the cylinder head face on a used engine exceeds the specification for service wear, the following components must be replaced. Illustration 88 g00314806 Measure the radial movement of the valve in the valve guide. (1) Valve guide (2) Radial movement of the valve in the valve guide (3) Valve stem (4) Dial indicator (5) Valve head Valves 1. Place a new valve in the valve guide. Valve inserts 2. Place a dial indicator with a magnetic base on the face of the cylinder head. For the wear limits for the inlet valves and exhaust valves, refer to Specifications, “Cylinder Head”. 5. Check each valve for cracks.

Check the stems of the valves for wear. Ensure that the valves are the correct fit in the valve guides. Refer to Systems Operation, Testing and Adjusting, “Valve Guide - Inspect” for the procedure to inspect the valve guides. 3. Lift the edge of the valve head to a distance of 15.0 mm (0.60 inch). 4. Move the valve in a radial direction away from the dial indicator. Make sure that the valve moves away from the dial indicator as far as possible. Position the contact point of the dial indicator on the edge of the valve head. Set the position of the needle of the dial indicator to zero. 6. Check the load on the valve springs.

Refer to Specifications, “Cylinder Head Valves” for the correct lengths and specifications for the valve springs. 5. Move the valve in a radial direction toward the dial indicator as far as possible. Note the distance of movement which is indicated on the dial indicator. If the distance is greater than the maximum clearance of the valve in the valve guide, replace the valve guide. i03577785 Valve Guide - Inspect The maximum clearance for the inlet valve stem in the valve guide with a valve lift of 15.0 mm (0.60 inch) is the following value. Perform this test in order to determine if a valve guide should be replaced. . . . . . . . . . . . . . . . . . . . . . .

0.26 mm ((0.01024 inch)) The maximum clearance for the exhaust valve stem in the valve guide with a valve lift of 15.0 mm (0.60 inch) is the following value. . . . . . . . . . . . . . . . . . . . . . . 0.33 mm ((0.01299 inch))