21. STANDARD TIGHTENING TORQUES FOR BOLTS AND NUTS 21.2 TORQUE LIST Unless otherwise specified, tighten the metric bolts and nuts to the torque shown in the table. The tightening torque is determined by the width across the flats @ of the nut and bolt. If it is necessary to replace any nut or bolt, always use a Komatsu genuine part of the same size as the part that was replaced. Nm (newton meter): INm + 0.1 kgm + 0.74 ibft Thread diameter of bolt (mm) (a) Width across flat (mm) (b) Nm A0054300 km Ibft b) 6 10 13.2 f 1.4 8 13 31.4 f 2.9 10 17 65.7 k 6.8 12 19 112 LIZ 9.8 14 22 177f19 1.35 + 0.15 3.2 zt 0.3 6.7 f 0.7 11.5 * 1.0 18.0 I?
2.0 9.73 f 1.03 23.2 i 2.1 48.5 k 5.0 82.6 + 7.2 131 * 14 16 24 279* 29 18 27 383k 39 20 30 549k 58 22 32 745+ 78 24 36 927 + 98 28.5 k 3 39* 3 56 zt 6 76 + 8 94.5 f 10 206 rt 21 282+ 29 405 f43 549 k 58 684 f 72 27 41 1320+ 140 30 46 1720+ 190 33 50 221Ok 240 36 55 2750 k 290 39 60 3280 + 340 135+15 175 + 20 225+ 25 280 + 30 335 i 35 973 *loo 127Ort 140 1630 k 180 2030f210 2420+ 250 When tightening panels or other parts having tightening fixtures made of plastic, be careful not to use excessive tightening torque: doing so will damage the plastic parts. NOTICE 3-15