Operating & maintenance manual 13.1.3 Compaction measurement Variant 1 • An easy-to-install measurement system which serves to inform the driver of the degree of soil compaction. • The compaction of the soil is continuously measured by an acceleration measurement device. • If the degree of compaction increases, the acceleration of the drum is increased, which, in turn, causes the values on the instrument to increase as well. • As soon as the maximum compaction capacity of your vehicle has been reached, the maximum degree of compaction is set as a fixed value. • The process of compacting the soil can then be terminated.
• In case no solid value can be established, an analysis of the roadbed is required. The following parameters are displayed: The relative degree of compaction The more the soil is compacted, the higher the respective value. The frequency Displays the current frequency of the vibration drive as a numerical value in Hertz [Hz]. • Jump Operation on soil which has been compacted too much can cause the vehicle to jump. Fig. 77 Compaction measurement 13.1.4 Installing and dismantling the compaction measurement system Installing and dismantling the compaction measurement system in the cab is easy. Removing it from the cab after each operation prevents the device from being stolen or damaged.
Attach/ remove the protecting caps of the plug-in connections. Screw on/off the plug-in connections ( 3 ) of the compaction measurement system. Make sure the mounting brackets ( 4 ) click into place. / Unlock the mounting brackets Remove the compaction measurement system from the mounting. 2 3 Fig. 78 Compaction measurement 65 NOTICE Material damage! If the vehicle starts to jump, immediately stop operating the compaction roller.