hyundai — 8067024 pf2510 EN 03 17

Operating & maintenance manual 21.3 Maintenance work referring to the rear axle 21.3.1 Checking the oil level in the wheel drives and changing oil Check the oil level in the rear axle and in the wheel drives after the 50 initial operating hours and subsequently, at intervals of 500 operating hours . Checking the oil level in the wheel drives: Advance the compaction roller until the oil drain plug ( 1 ) is in the correct position (see photo on the left). Unscrew the oil drain plug ( 1 ). The oil level should be barely visible underneath the opening or tangible with a finger.

In case oil needs to be added, be sure to consult the Table of lubricants for information on the required specifications. Screw the oil drain plug ( 1 ) back in. Oil change in the wheel drives: In order to replace the oil in the wheel drives, advance the compaction roller until the oil drain plug ( 1 ) is in the lowest position (6 o‘clock). Place a sufficiently dimensioned receptacle under the respective wheel drive. Unscrew the oil drain plug ( 1 ) and drain the oil. Screw the oil drain plug ( 1 ) back in and add axle oil by following the instructions above. 1 Fig. 112 Oil level in the wheel drives 1 Fig.

113 Oil change wheel drives 94 SAFETY Before carrying out any maintenance work related to the rear axle, refer to the table of lubricants for information on the required type of axle oil. INSTRUCTIONS WARNING Risk of injuries and accidents caused by insufficient safety measures and inexperienced maintenance work  Take the compaction roller to a workshop in order to carry out the oil check.  Before carrying out any work related to the rear axle, secure the compaction roller against rolling.  Apply the parking brake and put wheel chocks under the tires. NOTICE Environmental protection! Prevent the oil from penetrating the ground, polluting water or leaking into the sewer system.