hyundai — 8067024 pf2510 EN 03 17

Operating & maintenance manual 21.3.2 Oil level check and oil change in the rear axle Check the oil level in the rear axle after the initial 50 operating hours and subsequently, at intervals of 500 operating hours . Checking the oil level in the axle housing The filler screws ( 2 ) and the oil drain plugs ( 3 ) must point backwards (direction of motion). Uscrew the filler screws ( 2 ) and remove them from the axle housing. The oil level should be barely visible underneath the opening or tangible with a finger. Screw the filler screws ( 2 ) back in. Replacing the oil in the axle housing Place a sufficiently dimensioned oil receptacle under the three oil drain plugs ( 3 ).

Unscrew the oil drain plugs ( 3 ) and drain the oil. Dispose of the waste oil in an environmentally friendly way. EU waste disposal key: 130202 (EU). Screw the oil drain plugs ( 3 ) back in. Refer to the table of lubricants for information on the required specifications of the axle oil. Provide the axle housing with new axle oil via the filler screws ( 2 ). Attach and tighten the filler screws ( 2 ). Fig. 114 Oil level and oil change- rear axle 95 NOTICE  Prior to carrying out any maintenance work at the rear axle, please inform yourself of the permissible axle oil specifications, see Table of lubricants.  Take the compaction roller to a workshop in order to carry out the oil check.

 Before carrying out any work related to the rear axle, secure the compaction roller against rolling: Apply the parking brake and put wheel chocks under the tires.