Operating & maintenance manual 21.3.3 Maintenance work referring to the drum and vibration drive 21.3.4 Oil level check: drum drive Check the oil level at the drum drive after the initial 50 operating hours and subsequently, at intervals of 500 operating hours . Advance the compaction roller until the label ( 1 ) at the gear flange is visible and points upward. The filler and the oil drain screw ( 2 , 3 ) are both situated on the interior gear side Y. If the label ( 1 ) is in the correct position, the control screw ( 2 ) is on the left side and the drain screw (3) points downward. Remove the filler screw ( 2 ) from the gear box.
The oil level should be tangible with a finger underneath the opening. If required, add the necessary amount of gear oil. Be sure to consult the Table of lubricants for information on the specifications of the required gear oil. 1 Y 2 3 Fig. 115 Drum drive 21.3.5 Oil level check: vibration drive Check the oil level at the vibration drive after the initial 50 operating hours and subsequently, at intervals of 500 operating hours . Advance the compaction roller until the inspection glass ( 4 ) is in the lowest position (6 o‘clock) ( 4.1 ). This implies that the filler screw (4) is in the top position (12 o‘clock).
If, in this position, the oil level does not correspond to the illustration ( 4.2 ), oil needs to be added. Be sure to consult the table of lubricants for information on the specifications of the required oil (engine oil 15W40). Remove the filler screw ( 4 ) from the housing. Add oil until the correct oil level is reached, see illustration. Screw the filler screw back in. 4 4.1 4.2 Fig. 116 Vibration drive 96 SAFETY INSTRUCTIONS Before carrying out any maintenance work related to the components of the drum, be sure to consult the Table of lubricants for information on the specifications of the required type of oil. In addition, clean the drum area to prevent dirt from contaminating the oil.
WARNING Risk of injuries and accidents caused by insufficient safety measures and inexperienced maintenance work Take the compaction roller to a workshop in order to carry out the oil check. Before carrying out any work related to the rear axle, secure the compaction roller against rolling. Apply the parking brake and put wheel chocks under the tires.