Operating & maintenance manual 21.4 Maintenance work referring to the electrical system 21.4.1 Maintenance work related to the battery Check the battery poles ( 2 ) for the accumulation of dirt and for signs of corrosion. Lubricate the poles and terminals. Grease: order no. 0830684. 21.4.2 Printed circuit board, fuses and relays Check the printed circuit board ( 3 ), particularly fuses F24 ( 5 ), F18 ( 6 ) and relay K42 ( 7 ). 7 3 The printed circuit board is installed next to the driver’s seat (on the left) and is covered by a faceplate. Open the faceplate ( 3 ) covering the printed circuit board ( 4 ) and check the printed circuit board by conducting a visual inspection.
Always replace defective fuses by new ones, see Maintenance instructions for the service staff . 6 5 4 Fig. 118 Printed circuit board Fuses and relays in the engine compartment: Check fuses F17 , F100 and relay K13 in the engine compartment for the accumulation of dirt and damage. Always replace defective fuses, see table below for the allocation of the fuses on the printed circuit board. K13 F100 F17 Fig. 119 Fuses and relays 97 WARNING Risk of explosions and injuries Battery gases are highly explosive. Keep away sparks and open fire from the battery. Do not smoke. Avoid all skin contact with battery acid, as it may lead to severe chemical burns! Protect your eyes and your skin! 2 Fig.
117 Battery