hyundai — 8067024 pf2510 EN 03 17

Operating & maintenance manual 22 Cleaning and preservation 22.1 Cleaning the engine The accumulation of dust on the cooling fins, particularly in combination with fuel and oil, reduces the cooling capacity. The most suitable cleaning method depends on the kind of soiling: Steam jet: We recommend cleaning the engine by means of a steam jet. Carry out the cleaning at a temperature of 80 to 90 єC (176 to 194 єF) and use a pressure of approx. 60 bar (870.23 psi). . Compressed air: Compressed air is to be used to remove minor, dry dirt only. Start blowing at the exhaust side. Water and solvent:

In case water and solvent are used to clean the engine, use solvents which dissolve compounds of dust, fuel and lubricants. Apply the solvent by means of a brush. Let it set before washing it down with water. Clean the protective grid, the engine cooling fan and the air guiding plates. Never point directly at sensitive parts, e.g. the fan wheel. Prevent the cleaning fluid from reacting with electrical components. After a thorough and careful cleaning, run up the engine in order to cause the remaining water to vaporize, thus preventing corrosion. 22.2 Long-term storage Remove the battery. Store it in a frost-proof room. Fill and recharge it at regular intervals.

In case the compaction roller is put out of operation for more than 6 months: Thoroughly lubricate all greasing points. Replace the engine oil by anti-corrosive oil. Add 10% of anti-corrosive oil to the fuel. Fill the tank to the top. Run the Diesel engine for a few minutes. Seal the air filter suction hose and the muffler by means of duct tape and plastic foil. In areas with a high humidity (tropical regions), fill the hydraulic tank to the top. Apply a thick film of anti-corrosion grease to all exposed cylinder piston rods. 99 WARNING Risk of property damage and health hazards! Never use fuel to clean the engine!

The cleaning effect is poor and it is harmful both to your health and the environment. NOTICE Material damage! With biodiesel, standstill periods of more than 4 weeks are to be generally avoided.