Komatsu — BEFORE STARTING ENGINE

. OPERATION MACHINE OPERATIONS AND CONTROLS Check Oil Level in Hydraulic Tank, Add Oil WARNING the engine is stopped, and may cause burns. Wait for the 2) When carrying out inspection in the condition B shown in bucket cylinders, raise the boom to the maximum height, then stop the engine. 2. Inspect sight gauge (G) from the small inspection hole in the right cover. The oil level should be within the range given below. Condition A: Within range a Condition B: Within range b 3. When the level is below the L mark, open mud cover (1), loosen 3 - 115 The parts and oil are at temperature to go down b When removing the oil fill er cap, turn it slowly to release the i 1.

When checking the oi l level in the hydraulic tank, set t he machine in the following condit t inspection in the condition A s hown in ht, start the engine, run the engin e at low blade to the ground, retract the arm and ower the boom to bring the buck et teeth he ground, then stop the engine ht, start the engine, run the engin e at low blade to the ground, extend the arm and NOTICE Do not add oil above the H li ne. This will damage the hydraulic circuit or cause the oil to spurt out.

If oil has been added above th e H level, stop the upper structure s o that the drain plug (P) under the hyd raulic tank will be between both tra cks, and stop the engine and wait for the hydraulic oil to cool down, then drain the excess oil from drain plug (P ). bolt (2), remove plate then add oil through o (3) at the top surface of oil filler port (F), il filler port (F).