TROUBLESHOOTING / Troubleshooting A MC FAULT CODE 11202 Disconnect connector MC-D of MC. Check for continuity in harnes between terminal #D4 of harness end of connector MC-D in MC and terminal #2 in pump 2 delivery pressure sensor. YES Open circuit in harness between MC and pump 2 delivery pressure sensor. YES NO To A Check if voltage between terminal #1 of harness end of connector in pump 2 delivery pressure sensor and machine is specification. YES Open circuit in harness between MC and pump 2 delivery pressure sensor (terminal #3). Switch pump 1 delivery pressure sensor with pump 2 delivery pressure sensor and retry. Check if fault code is switched. · Key switch:
ON NO Open circuit in harness between MC and pump 2 delivery pressure sensor (terminal #1). NO · Key switch: ON · Specification: More than 0.25 V, Less than 4.5 V Faulty pump 2 delivery pressure sensor. YES Connector (Harness end of connector viewed from the open side) Check if voltage be- tween terminal #D4 of harness end of con- nector MC-D and machine is 0 V. YES Faulty MC. A MC Connector MC-D Pump 2 Delivery Pressure Sensor Shorted circuit in harness between MC and pump 2 delivery pressure sensor. #D4 NO · Key switch: ON 1 2 3 T183-05-04-009 T5-5-76 Fault Code Trouble Cause Influenced Control 11202-3 Abnormal Pump 2 Delivery Pressure Sensor High Voltage Voltage:
4.5 V or higher • HP Mode Control • Travel HP Mode Control • E Mode Control • Travel Torque-Up Control • Arm Regenerative Control • Digging Regenerative Control • Travel Motor Swash Angle Se- lection Control 11202-4 Abnormal Pump 2 Delivery Pressure Sensor Low Voltage Voltage: Less than 0.25 V • HP Mode Control • Travel HP Mode Control • E Mode Control • Travel Torque-Up Control • Arm Regenerative Control • Digging Regenerative Control • Travel Motor Swash Angle Se- lection Control Disconnect connector of pump 2 delivery pressure sensor. Check if voltage between terminals #1 NO and #3 of harness end of connector is 5±0.5 V.