TROUBLESHOOTING / Troubleshooting A MC FAULT CODE 11302 Check if voltage be- tween terminal #D15 of harness end of connector MC-D and machine is 0 V. A Connector (Harness end of connector viewed from the open side) Shorted circuit in harness between MC and boom raise pilot pressure sensor. · Key switch: ON NO MC Connector MC-D Pilot Pressure Sensor (Boom Raise) T183-05-04-009 T5-5-80 Fault Code Trouble Cause Influenced Control 11302-3 Abnormal Boom Raise Pilot Pressure Sensor High Voltage Voltage:
4.75 V or higher • HP Mode Control • Arm Regenerative Control • Digging Regenerative Control • Auto-Power Lift Control • Attachment Flow Rate Control 11302-4 Abnormal Boom Raise Pilot Pressure Sensor Low Voltage Voltage: Less than 0.25 V • HP Mode Control • Arm Regenerative Control • Digging Regenerative Control • Auto-Power Lift Control • Attachment Flow Rate Control Disconnect connector Open circuit in harness MC-D of MC. YES between MC and boom Check for continuity in raise pilot pressure sensor. YES harnes between terminal #D15 of harness end of connector MC-D in MC To A Disconnect connector and terminal #2 in NO of boom raise pilot boom raise pilot pressure sensor. pressure sensor.
NO Check if voltage between terminals #1 and #3 of harness end Open circuit in harness of connector is 5±0.5 between MC and boom Check if voltage V. YES raise pilot pressure between terminal #1 of Switch boom raise pilot · Key switch: ON harness end of sensor (terminal #3). pressure sensor with connector in boom other pressure sensor NO raise pilot pressure and retry. sensor and machine is Open circuit in harness Check if fault code specification. between MC and boom disappears. NO raise pilot pressure · Key switch: ON sensor (terminal #1). · Specification: More than 0.25 V, Less than 4.75 V Faulty boom raise pilot YES pressure sensor.
Open circuit in harness between MC and boom raise pilot pressure sensor. Faulty boom raise pilot pressure sensor. YES Disconnect connector of boom raise pilot pressure sensor. Check if voltage NO between terminals #1 and #3 of harness end of connector is 5±0.5 V. YES Faulty MC. #D15 1 2 3