hitachi — CAN Harness Check MC Fault Code 11910, 11914, 11920

TROUBLESHOOTING / Troubleshooting A Shorted circuit in CAN harness between power circuit and CAN circuit. YES Shorted circuit in CAN harness between key signal circuit and CAN circuit. YES YES Shorted circuit in CAN harness. · Key switch: OFF · Refer to “Discontinuity Check between CAN Circuit and Key Signal Circuit”. YES To A · Key switch: OFF · Refer to “Discontinuity Check in CAN Harness”. To B · Key switch: OFF Connector · Key switch: OFF MC Connector MC-C (Harness end) #C15 C23 C31 ECM Connector (Harness end) #18 #37 T1GR-05-04-002 T5-5-95 Check for continuity between key signal circuit (MC, ICF, NO ECM, monitor unit) and CAN circuit.

Check for continuity between High side NO and Low side in CAN harness. Connect all connectors except connector MC-C in MC. Check if resistance between terminals NO #C4 and #C15 of harness end of connector MC-C is within 60±10 Ω. Disconnect connector in MC. Connect connector of harness end. NO Check if resistance between terminals #18 and #37 of connector in ECM is within 120±10 Ω. #C4 1 C10