TROUBLESHOOTING / Troubleshooting A Connector ECM Connector (Harness end) ICF Connector ICF-C (Harness end) #18 #37 #C5 T1GR-05-04-002 T1V1-05-04-002 #C11 T5-5-100 NO Check the connections of Connect connector MC and connector. in MC. Check if fault A code 11004-2 is displayed. Faulty MC. YES · Key witch: ON Check the connections of NO Connect connector monitor unit and in the monitor unit. connector. YES Check if fault code 11004-2 is displayed. Faulty monitor unit. YES · Key witch: ON Connect connector NO Check the connections of B in ECM. ICF and connector. YES Check if fault code Connect connector in 11004-2 is the monitor unit. displayed. Faulty ICF. Disconnect YES connector ECM.
· Key witch: ON Check if resistance between terminals NO Check the connections of NO # h1 a8 rn a en sd s e# n3 d7 oo ff C ECon Mn .e c t connector in C ino In Cn Fe . c t connector ICF and connector. YES connector is within Disconnect Check if fault code 120±10 Ω. connector ICF-C in 11004-2 is Faulty ICF. ICF. displayed. · Key witch: OFF YES Check if resistance · Key witch: ON between terminals NO #C5 and #C11 of harness end of connector is within Failure in any controller in 60±10 Ω. MC, ICF, ECM or monitor NO unit. · Key witch: OFF NO Check the connections of MC and connector. Failure in any controller in MC, ICF, ECM or monitor unit. Connect connector in the monitor unit.
Check if fault code YES 11004-2 is displayed. Connect connector in ECM. Check if fault code YES 11004-2 is displayed. Connect connector in the monitor unit. Disconnect connector ECM. Check if resistance between terminals #18 and #37 of NO harness end of connector is within 120±10 Ω. Connect connector in ICF. YES Check if fault code 11004-2 is displayed. NO Faulty ICF. YES NO #C5 and #C11 of harness end of connector is within 60±10 Ω.