hitachi — Precautions for Inspection and Maintenance

TROUBLESHOOTING / Electrical System Inspection 3. Precautions for connecting and disconnecting terminal connectors. 1) When disconnecting the harnesses, grasp them by their connectors. Do not pull on the wire itself. Release the lock first before attempting to separate connectors, if a lock is provided. (Refer to “Instructions for Disconnecting Connector” on page T5-7-3.) 2) The water-resistant connectors keep water out. If water enters them, water will not easily drain from them. When checking the water-resistant connectors, take extra care not to allow water to enter the connectors. In case water should enter the connectors, reconnect only after the connectors are thoroughly dried.

3) Before connecting terminal connectors, check that no terminals are bent or coming off. In addition, as most connectors are made of brass, check that no terminals are rusting. 4) When connecting terminal connectors provided with a lock, insert them together until the lock “clicks.” 5) Pull the harness near the connector in order to check if it is correctly connected. 4. Precaution for using a circuit tester. 1) Before using a circuit tester, refer to the instructions in the circuit tester manual. Then, set the circuit tester to meet the object to be measured, voltage range and current polarity.

2) Before starting the connector test, always check the connector terminal numbers, referring to the circuit diagram. When the connector size is very small, and the standard probe size is too large to be used for testing, wind a fine piece of sharpened wire or a pin around the probe to make the test easier. 3) When checking the connector by using a tester, insert a tester probe from the harness end of connector in order not to damage the terminal inside connector.

Right Wrong T107-07-06-001 Right Rust (Deformation) Wrong Wrong (Separation) T107-07-06-002 T107-07-06-003 T5-7-2 Wind a Piece of Wire Tester Probe Sharpen the end of the Wire Wind a Piece of Wire Tester Probe Sharpen the end of the Wire