hitachi — Instructions for Disconnecting Connectors

TROUBLESHOOTING / Electrical System Inspection INSTRUCTIONS FOR DISCONNECTING CONNECTORS Push, Unlock and Separate Type NOTE: 1. Connectors will not be easily separated even if the lock is pushed while being pulled. Push the lock first before pulling the connectors. 2. The lock is located on female side con- nector (harness end side).

T107-04-05-002 Locations of This Type Connector Fuel Gauge Pump Delivery Pressure Sensor Radio Hydraulic Oil Level Switch General Relay Speaker Horn Solenoid Valve Wiper Cab Harness Diode Monitor Unit Pressure Sensor Key Switch ECM Washer Engine Control Dial ICF Raise Lock, Pull and Separate Type Locations of This Type Connector Starter Relay 2 Pull and Separate Type IMPORTANT: Before pulling and separating, re- lease the lock of connector in the solenoid valve by using a pair of pincers. Locations of This Type Connector Hydraulic Oil Temperature Sensor Dr. ZX T107-04-05-003 T107-04-05-004 T5-7-3