hitachi — Continuity Check

TROUBLESHOOTING / Electrical System Inspection CONTINUITY CHECK Single-line continuity check Disconnect both end connectors of the harness and check continuity between both ends: If the ohm-meter reading is: 0 Ω = Continuity Ω = Discontinuity Harness A a NOTE: When the one end connector is far apart from the other, connect one end of connector (A) to the machine chassis using a clip. Then, check continuity of the harness through the vehicle frame as illustrated. If the ohm-meter reading is: 0 Ω = Continuity Ω = Discontinuity Single-line short-circuit check Disconnect both end connectors of the harness and check continuity between one end connector of the harness and the vehicle frame:

If the ohm-meter reading is: 0 Ω = Short circuit is present. Ω = No short circuit is present. Ω Connect to the vehicle frame. A a Connect to the vehicle frame. Ω A a Ч Short-circuit between the harness and the vehicle frame. Ω T107-07-05-003 T5-7-8