INJECTION NOZZLE (2) Inspecting spray condition Pump the lever on the nozzle tester A at a rate of about 1-2 seconds per stroke, and maintain a continuous spray. B: Even spray from all five injection orifices (Good) C: Even and symmetrical spray (Good) D: Asymmetrical spray (Bad) E: Branched spray (Bad) F: Thin spray (Bad) G: Irregular spray (Bad) 06931 If the spray is unsatisfactory, disassemble and clean the injection nozzle assembly 5 , then inspect the spray again. If the spray is still unsatisfactory, replace the injection nozzle assembly 5 . Check that no fuel drips from the nozzle after the spray is complete. WARNING Do not touch the spray that comes out of the nozzle.
(3) Inspecting for leaks Slowly increase the nozzle pressure to 1.96 MPa (20 kgf/cm 2 ) [284.3 psi] below the specified valve opening pressure. Maintain this pressure for 10 seconds and check that no fuel drips from the end of the nozzle. If the injection nozzle assembly 5 appears defective, disassemble and clean it, then inspect it again. If the injection nozzle assembly 5 still appears defective, it must be replaced. 05388 Injection nozzle assembly [Disassembly] 5 CAUTION Do not touch the sliding parts A of the needle valve 7. Do not change the needle valve 13 and nozzle 12 combination on each cylinder.
04744 [Cleaning] Wash the needle valve 13 and nozzle 12 in gas oil, then use the Cleaning Tool Set to remove any carbon deposits in accordance with the following procedure. Remove carbon from the end of the needle valve 13 using the Cleaning Bar of the Cleaning Tool Set. CAUTION 04556 Do not use a wire brush or any hard metallic object for cleaning. 13-30