54 9 Installation of rear bracket A: Alignment marks 13528 Installation of conical washer Install the conical washer 10 in the illustrated direction in the rear bracket 9 . 10 10766 Removal of yoke & brush holder assembly To remove the yoke & brush holder assembly, proceed as described below, while using care to prevent damage to the commutator A of the armature assembly 17 by the brushes 14 and 15 . Keep the brushes 14 and 15 apart from the commutator A and hold the brush spring 13 alongside the brushes. 11 16083 Remove the yoke & brush holder assembly 11 from the front bracket assembly 25 . CAUTION When the yoke & brush holder assembly 11 is removed, do not tilt it downward.
Otherwise, the armature assembly 18 may fall down. 20017 For installation, reverse the order of removal. 13 Inspection of brush spring Use new brushes 14 and 15 and measure the load at the moment the brush spring 13 leaves the brushes as shown. If the reading is less than the limit, replace the brush spring 13 . 20466 54-39