Caterpillar — Caterpillar 99709-68120 — user manual

11 [Installation] Install the valve guides 15 , 16 using the Valve Guide Installer. Strike the Valve Guide Installer until it sits snugly on the cylinder head 20 . CAUTION The valve guides 15, 16 must be pressed in to the specified depth. Be sure to use the Valve Guide Installer for this operation. Exhaust valve guides 15 are longer than inlet valve guides 16. Be sure to install the correct type of guide in each location. 02220 Valves and valve seats [Inspection] Apply an even coat of minimum to the valve seats 17 , 18 surface A that makes contact with the valves 7 , 8 . Using the Valve Lapper, strike the valves 7 , 8 against the valve seats 17, 18 once.

Do not rotate the valve during this operation. NOTE Carry out these inspections after inspecting the valves and valve guides. 18 17 8 7 01968 If the minimum deposited on the valves 7 , 8 indicate a poor contact pattern, rectify the contact pattern as follows: 01969 [Refacing] Lap the valve in accordance with the following procedure: Apply a thin, even coat of lapping compound to the surface A of the valves 7 , 8 that makes contact with the valve seats 17 , 18 . CAUTION Ensure that no compound adheres to the stem B of the valves 7, 8. 01970 NOTE Start with intermediate-mesh compound (120 to 150 mesh) and finish with fine-mesh compound (200 mesh or more).

The addition of a small amount of engine oil makes lapping compound easier to apply. 11-25 Contact Corrective action Minor defect Lapping Serious defect Reface or replace valve and valve seat