Caterpillar — Caterpillar 99709-68120 — user manual

CYLINDER HEAD AND VALVE MECHANISM Using the Valve Lapper, lightly strike the valves 7 , 8 against the valve seats 17 , 18 while turning it little by little. Wash away the compound with gas oil or a similar fluid. Apply engine oil to the contact surfaces of the valve seats 17 , 18 and rub it in so that the contact surfaces are lubricated and mate together snugly. Inspect the contact pattern of the valves 7 , 8 and valve seats 17 , 18 once more. If the contact pattern is still defective, replace the valve seats 17, 18. 01971 Valve seats [Inspection] (1) Valve seat width If the measurement exceeds the specified limit, rectify or replace the valve seats 17 , 18 . 18 17 A :

Valve seat width 01975 NOTE Whenever the valve seats 17, 18 are rectified or replaced, be sure to lap the valve seats 17, 18 and valves 7, 8. P.11-25 (2) Valve sinkage from cylinder head bottom surface If any measurement exceeds the specified limit, rectify or replace the defective part(s). B : Valve sinkage 02265 [Rectification] Grind the valve seats 17 , 18 using a valve seat cutter or valve seat grinder. After grinding, put some sandpaper of around #400 grade between the cutter and valve seat and grind the valve seat lightly. Use a 15° or 17° cutter to achieve the specified valve seat width A . 01977 C :

Valve seat angle CAUTION Ensure that grinding does not cause the valve sinkage B to exceed the specified limit. After rectification, lap the valves 7 , 8 and valve seats 17 , 18 . P.11-25 11-26