Caterpillar — Caterpillar 99709-68120 — user manual

11 [Removal] Valve seats 17 , 18 are installed by expansion fitting. To remove a valve seat, grind the inside surface to reduce its thickness, then remove the valve seat at room temperature. D : Material to remove 01973 [Installation] Check that the valve seat hole diameters E , F in the cylinder head 20 conform with the values shown below. Unit: mm(in.) 01976 Cool the valve seats 17 , 18 by immersing it in liquid nitrogen. Install the valve seats 17 , 18 in the cylinder head 20 using the Caulking Tool Body and Installer Ring. After installing the valve seats 17 , 18 , lap the valve seats and valves 7 , 8 .

P.11-25 01974 20 Inspecting cylinder head Measure the extent of distortion in the cylinder head's bottom surface. If the degree of distortion exceeds the specified limit, rectify the distortion with a surface grinder. CAUTION 01978 Ensure that grinding does not cause the cylinder head's top surface-to-bottom surface distance to fall below the specified limit. 11-27 Dimension Inlet valve seat hole (E) φ51 +0.03 0 (φ2.01 +0.001 0 ) Exhaust valve seat hole (F) φ44 +0.025 0 (φ1.73 +0.001 0 )