PISTONS, CONNECTING RODS, AND CYLINDER LINERS With the piston’s “ ” front mark facing the front of the engine, install the piston and connecting rod assembly in accordance with the following procedure. D : Front of engine 03384 Fit the Piston Guide Clamp over the piston skirt. Using the bolt E of the Piston Guide Lever, adjust the clamp's inside diameter such that it matches the piston's outside diameter. Move the Piston Guide Clamp and Piston Guide Lever to the top of the piston. 11651 02011 With the piston installed, align the mating marks F on the connecting rod and connecting rod cap 3 and tighten the bolts to the specified torque.
Then, tighten the bolts 1 further in accordance with the following procedure. 01990 Before fitting the Socket Wrench over a bolt, turn the holder G counter-clockwise to tension the built-in spring. H : Socket J : Rod K : Rod (extension) 01991 11-32