Caterpillar — Caterpillar 99709-68120 — user manual

11 Set the socket wrench such that the built-in spring force forces the rod K against the crankshaft. On the holder G , select the inscribed line L that is easiest to see. Using the selected line as a reference, turn the socket H 90° ± 5° clockwise. (One gradation on the scale M represents 5°.) NOTE After fitting the connecting rod caps 3, inspect the following items: Connecting rod end play ( P.11-30) Piston projections ( P.11-30) 11652 Piston-and-connecting rod assembly and cylinder liners [Inspection] If any clearance is out of specification, replace the defective part(s). 6 5 A : Outside diameter measurement position B : Direction of crankshaft axis C :

Perpendicular to crankshaft axis NOTE The cylinder liners are of a thin design and cannot be bored to oversize dimensions. To prevent deformation of the cylinder liners, do not remove them except for replacement. 03375 02003 Cylinder liners [Removal] NOTE If any cylinder liner 6 must be reused after removal, make an alignment mark with paint and use this mark to reinstall the cylinder liner in its original position. 02004 11-33