FLYWHEEL N Service procedure Flywheel assembly [Removal] To remove the flywheel assembly 4 , screw the mounting bolts 2 into the removal holes A . 4 02052 [Installation] The bolts 2 can be used only three times. Before refitting the bolts, make a punch mark on the head of each one to indicate times of reuse. CAUTION If any bolt already has three punch marks, it must not be reused any more; replace it with a new one. 01991 Tighten the bolts 2 to their specified torque, then tighten them further in accordance with the following procedure: Turn the holder B of the Socket Wrench counter-clockwise to tension the built-in spring. C : Socket D : Rod E :
Rod (extension) Set the Socket Wrench such that the built-in spring forces the rod E against the Magnetic Base. On the holder B , select the inscribed line F that is easiest to see. Using the selected line as a reference, turn the socket 150° clockwise. (One gradation on the scale G represents 5°.) CAUTION Since the bolts 2 utilize the plastic region tightening method, they must not be tightened further after this procedure. 14312 [Inspection] (1) Runout Tighten the bolts 2 to their specified torque. If runout exceeds the specified limit, check that the bolts 2 are tightened correctly and inspect the crankshaft * mounting surface. Then, rectify or replace the flywheel assembly 4 as required.
02055 11-44