11 (2) Height of friction surface If the measurement is below the specified value, rectify or replace the flywheel assembly 4 . H : Height of friction surface 03349 (3) Distortion of friction surface If distortion exceeds the specified limit, rectify or replace the flywheel assembly 4 . NOTE If any abnormality is evident on the ring gear 6, replace the ring gear before making inspections. 02054 [Rectification] Grind the friction surface such that its height H remains greater than the specified minimum. The friction surface must remain parallel with surface J with a tolerance of 0.1 mm (0.00394 in.). 03351 Ring gear [Inspection] Inspect the ring gear 6 for damage and abnormal wear.
If any defect is evident, the ring gear must be replaced. 6 [Removal] Heat the ring gear 6 evenly with an acetylene torch or the like. CAUTION Be careful not to get burned. Remove the ring gear 6 from the flywheel 7 by tapping around its entire periphery. 02057 11-45