Caterpillar — Caterpillar 99709-68120 — user manual

FLYWHEEL [Installation] Using a piston heater or the like, heat the ring gear 6 to approximately 100°C (212°F) for 3 minutes. CAUTION Be careful not to get burned. 03353 Fit the ring gear 6 with the non-chamfered side of its teeth toward the flywheel 7 . A : Chamfered side of ring gear Fitting rear oil seal Apply an even, unbroken bead of sealant A to the rear oil seal 8 in the position illustrated B . Fit the rear oil seal 9 onto the flywheel housing 10 within 3 minutes of applying the sealant A . 8 CAUTION Ensure that the sealant application position B on the oil seal 8 is clean before applying sealant.

When fitting the rear oil seal 8, hold it firmly in position to prevent spreading the sealant. After fitting the rear oil seal 8, wait at least 30 minutes before starting the engine. Apply a new bead of sealant A whenever the mounting bolts of the rear oil seal 8 have been loosened. 11702 Apply engine oil to the lip of the rear oil seal 8 . Fit the rear oil seal 8 onto the flywheel housing 10 in the direction illustrated. 02059 11-46