John Deere OMAL171363 (7430 and 7530) — Adjusting the Pivoting Fenders

Wheels, Tires 4. Also adjust the steering stops to make sure that neither the wheel nor the fender come into contact with tractor components (e.g. fuel tank). LX1031620 —UN—24APR06 OU12401,0001B7F -19-03MAR09-3/4 Tighten the screws to the following torque values: Screws (B) ............................ 140 Nm (105 lb-ft) Screws (A) ............................ 140 Nm (105 lb-ft) Screws (C) ............................ 190 Nm (140 lb-ft) A—Cap screws, support to base plate B—Cap screws, base plate to base C—Hex. socket screws, base to knuckle housing LX1033635 —UN—10MAY04 OU12401,0001B7F -19-03MAR09-4/4 Adjusting the Pivoting Fenders The fenders may be adjusted individually.

Several adjusting positions are possible. Tilt, width and height of the fenders can be adjusted depending on tire size. If the intention is to change between positions C and D, turn the part around (do NOT install it on the other side of the tractor). Then adjust the front-to-rear angle of adjusting arm (E). To make the adjustment, follow this procedure: A—Support to adjusting arm (wheel side) B—Support to adjusting arm (tractor side) C—Pivot plate (tractor side) D—Pivot plate (wheel side) E—Adjusting arm LX1038316 —UN—08AUG06 Continued on next page OU12401,0001B80 -19-03MAR09-1/4 65-5 030612 PN=166