Wheels, Tires 1. Raise front of tractor so that the front wheel drive axle can pivot freely. 2. Turn steering wheel in both directions and pivot the axle to determine the most suitable fender mounting position. LX1031619 —UN—31MAY06 3. Adjust fender position so that the minimum clearances (see illustration) are met. There must not be any contact with the tractor frame. 4. Adjust fender stop to prevent it from being seized at the edges with steering wheel fully turned and axle pivoting. Make sure that the stop contacts the tractor frame before the fender can hit the frame. A = 40 mm (1.57 in.), B = 60 mm (2.36 in.) LX1033894 —UN—11MAR04 OU12401,0001B80 -19-03MAR09-2/4 5.
Also adjust the steering stops to make sure that neither the wheel nor the fender come into contact with tractor components (e.g. fuel tank). LX1031620 —UN—24APR06 OU12401,0001B80 -19-03MAR09-3/4 Tighten the screws to the following torque values: Screws (A) ............................ 140 Nm (105 lb-ft) Screws (C) ............................ 140 Nm (105 lb-ft) Screw (B) .............................. 300 Nm (220 lb-ft) Screws (D) ............................ 190 Nm (140 lb-ft) LX1033893 —UN—11MAR04 A—Cap screws, support to adjusting arm B—Cap screw, adjusting arm to joint C—Cap screws, pivot plate to base D—Hex.
socket screws, base to knuckle housing OU12401,0001B80 -19-03MAR09-4/4 65-6 030612 PN=167