D Error codes – 2 Transmission 41 UDRF01.04GB Maintenance manual DRF 400–450 Description Limitation Action Con- nec- tion and compo- nent Diag- nostic menu Function group Code Dan a code 41.06 41.06 Incorrect gear selection from gear selector. Control unit doesn't allow change of range, however, opera- tion of machine is possible. Check cabling to gear selector with regards to signal range. - - 2.1.1 Gear and multi-func- tion lever 42.04 42.04 Actual gear ra- tio too low. Control unit indi- cates that one or several clutches are slipping. Check transmis- sion with purpose to understand if and, if that is the case, which clutch is slipping.
Check the set transmission ratio for the control unit. - - 2.3 Mechani- cal transmis- sion 42.05 42.05 Actual gear ra- tio too high. Control unit indi- cates that one or several clutches are slipping. Check transmis- sion with purpose to understand if and, if that is the case, which clutch is slipping. Check the set transmission ratio for the control unit. - - 2.3 Mechani- cal transmis- sion 43.03 43.03 Signal from Sensor engine rpm and oil temperature transmission outside valid range. Control unit indi- cates the error. Check cabling to sensor tempera- ture torque con- verter. Check sensor tem- perature torque converter.
D793/H3 - B758/ 766 TRANSM , menu 10 2.2.5 Sensor engine rpm and oil tem- perature transmission 43.07 43.07 Torque convert- er temperature exceeds 100 °C. Control unit indi- cates the error to make operator aware of the warning's level. Check cabling to sensor tempera- ture torque con- verter. Check sensor tem- perature torque converter. D793/H3 - B758/ 766 TRANSM , menu 10 2.2.5 Sensor engine rpm and oil tem- perature transmission