BAIC — BAIC Comanche Service Manual: Comprehensive Guide for PA-24 Series Aircraft

@-l 0- 2 ~3 @--4 t- S PIPER COMANCHE SERVICE MANl' AL 1. VALVECAP 2. CRUSH WASHER 3. "0" RING 4. WASHER 5 SPRING 6. BRASS WASHER 7. POSITION WASHER 8. VALVE STEM 9. PIN 10. PLUG COCK 11. VALVE BODY ~I --' I I I--._---.J FIGl'RE 8·11. THREE POSITIOS Ft:EL VALVE PA-24·180 AND PA·24·250 and disconnect the wiring. d. Remove the floor carpet and floor panel covering the selector. e. Disconnect the fuel lines. f. Remove the screws securing the valve mounting plate. The forward screws are secured by nuts while the aft screws are secured by plate nuts, Remove the valve from the aircraft. X-14. Servicing Three Position Fuel Valve.

(PA-24-180 and PA-24-250) The three position valve should be serviced every 400 hours or ",'hen there is an indication of valve binding. The binding of this valve (refer to Figure 8-11) is caused by fuel coming in contact with the plug and gradually removing the film of lubricant: presence of foreign material or the use of improper lubricants. a, With the valve removed from the aircraft. remove the vah .. e cap (I) and interior parts. b. Inspect the position washer (7) inner perimeter surface for indications of wear: should this be ..:\ idem, replace washer. c. Check the condition of plug cock (8) and valve body (II) for scored surfaces. The surface", if not badly scored.

may be conditioned by lapping with a fine polishing compound, Clean away all compound after lapping. If plug cock will not seat properly or if scoring remains evident. the valve should be replaced. d. Check the condition of the valve stem in the area where the "0" ring (2) seats. Should the stem be worn or damaged so that the "0" ring will not seal. replace the valve, e. With a lOx magnifying glass. inspect the valve plug cock for cracks. If cracks are visible. replace valve. f. Clean the valve of all foreign matter. lubricate the dry plug with a light film of MIL-G-6032. (Type I) grease.

turn the plug several times in its seat and wipe off any excess lubricant in the plug cock and valve pons. Lubricate position washer with a light film of MIL-G-6032 (Type I) grease, Reassemble the valve with a new '·0" ring. RE\'ISED: 11/1/82 2J3 Fl'EL SYSTE:\1