PIPER COMANCHE SERVICE MANUAL TABLE IX-VII. TROUBLESHOOTING (cont) ELECTRICAL SYSTEM ISSUED: 8/18/72 3 F3 Trouble Couse Remeely Motor fails to operate. (cont) Dirty commutator. Shorted, grounded, or open armature. A new brush should be run in until at least SO percent seated i however, if facilities are not avail- able for running in brushes, then the brush should be properly seated by insert- ing a strip of number 0000 sandpaper between the brush and commutator, with the sanded side next to the brush. Pull sand- paper in the direction of rotation, being careful to keep it in the same contou as the commutator. CAUTION Do not use coarse sandpaper or emery cloth.
After seating, clean thoroughly to remove all sand and metal particles to prevent excess!ve wear. Keep motor bearing free from sand or metal par- ticles. If commutator is rough or dirty. smooth and polish with number 0000 sand- paper, If too rough and pitted, remove and turn down: Blowout all par- ticles. Remove and replace with an armature known to be in lood condition.