Komatsu — HSS MOTOR

STRUCTURE, FUNCTION AND MAINTENANCE STANDARD HSS MOTOR Operation 2. Rotation speed and torque control As flow Q from the HSS pump is increased, motor speed N is heightened. Since the swash plate angle of the HSS 1. Operation of motor The pressurized oil sent from the pump enters cylinder block (5) and pushes piston (4) from the back face. In the case of the motor, the center line of plate (3) is always at an angle (swash plate angle a to the axial direction of cylinder block (5). As a result, if we take the example of one of pistons (4), oil pressure is applied to the back face of the right, and piston axial force FO is generated.

With shoe (16), which is joined to piston (4) by the spherical surface, reaction force FR in a direction at right angles to plane A is gen- erated. The combined force of FO and FR is FP , and this becomes the force to rotate cyl- inder block (5). motor is fixed ( is constant), torque T is proportional to pressure P . Swash plate angle is approx. 19°. Q = qN Q: Total flow (q = E – F) q: Flow per 1 turn N: Rotation speed T = P: Pressure T: Rotating torque Pq 2 π ------- Shaft (1), which is meshed to cylinder block (5) by spline (15) transmits this rotation torque to the output side.

Cylinder block (5) rotates, and while the con- dition changes from volume E to volume F , pressurized oil from the pump flows into the cylinder chamber, and pressure P is gener- ated according to the load. On the other hand, when the condition goes beyond volume F and changes to volume E , the oil is pushed out and returned to the pump. D85EX-15 10-63