Komatsu — MEASURING POWER TRAIN OIL PRESSURE

TESTING AND ADJUSTING MEASURING POWER TRAIN OIL PRESSURE 3. Measuring torque converter inlet pressure (IN) 1) Connect oil pressure gauge [1] of hydraulic tester F1 to oil pressure pick-up nipple (3). a Use an oil pressure gauge of 2.5MPa {25kg/cm 2 }. 4. Measuring transmission forward clutch pres- sure (FWD) 1) Connect oil pressure gauge [1] of hydraulic tester F1 to oil pressure pick-up nipple (4). a Use an oil pressure gauge of 5.9MPa {60kg/cm 2 }. 2) Start the engine and set the PCCS lever in the full neutral position. 2) Run the engine and set the parking brake lever in the FREE position. 3) Measure the oil pressure while the engine is running at low idling and high idling.

3) Press the brake pedal and set the PCCS lever in the FORWARD and 3rd gear speed position. 4) After finishing measurement, remove the measuring instrument and return the removed parts. a For the oil pressure gauge, see BPD11546. 4) Measure the oil pressure while the engine is running at high idling. Since the torque converter will be stalled, press the brake pedal securely and keep your right foot on the deceler- ator pedal for safety until the work is fin- ished. a For the oil pressure gauge, see BPD11546. 5) After finishing measurement, remove the mea- suring instrument and return the removed parts. 20-130 D85EX-15 (1)