Komatsu — MEASURING POWER TRAIN OIL PRESSURE

TESTING AND ADJUSTING MEASURING POWER TRAIN OIL PRESSURE 5. Measuring transmission reverse clutch pres- sure (R) 1) Connect oil pressure gauge [1] of hydraulic tester F1 to oil pressure pick-up nipple (5). a Use an oil pressure gauge of 5.9MPa {60kg/cm 2 }. 6. Measuring transmission 1st clutch pressure (1ST) 1) Connect oil pressure gauge [1] of hydraulic tester F1 to oil pressure pick-up nipple (6). a Use an oil pressure gauge of 5.9MPa {60kg/cm 2 }. 2) Run the engine and set the parking brake lever in the FREE position. 2) Run the engine and set the parking brake lever in the FREE position. 3) Press the brake pedal and set the PCCS lever in the REVERSE 3rd gear speed posi- tion.

3) Press the brake pedal and set the PCCS lever in the FORWARD and 1st gear speed position. 4) Measure the oil pressure while the engine is running at high idling. 4) Measure the oil pressure while the engine is running at low idling. Since the torque converter will be stalled, press the brake pedal securely and keep your right foot on the deceler- ator pedal for safety until the work is fin- ished. a For the oil pressure gauge, see BPD11546. Since the torque converter will be stalled, keep pressing the brake pedal securely. Do not raise the engine speed to high idling during measurement. a For the oil pressure gauge, see BPD11546.

5) After finishing measurement, remove the measuring instrument and return the removed parts. 5) After finishing measurement, remove the measuring instrument and return the removed parts. D85EX-15 20-131 (1)