TESTING AND ADJUSTING ADJUSTING BRAKE PEDAL ADJUSTING BRAKE PEDAL Tighten the locknuts of the rods and cables securely, and bend the cotter pins securely. 1. Adjust fitting dimension b of damper (2) so that the soroke of brake pedal (1) will be dimension a . Pedal stroke a : 77 mm Fitting dimension b of damper: 39 mm 2. Adjust fitting dimension c of rod (3) on the valve side, then connect to brake valve lever (4). Fitting dimension c of rod: 954 mm a Fully screw joint (5) into the valve side. 3. Adjust fitting dimension d of rod (6) on the pedal side, then connect to brake pedal (1). Fitting dimension d of rod: 195 mm 4.
Lightly push rod (3) on the valve side toward the rear of the machine, and turn only joint (7) to connect rods (3) and (6). a Push rod (3) with a force of about 9.8 – 19.6 N {1 – 2 kg}. Joint: 34.3 – 58.8 Nm {3.5 – 6.0 kgm} 20-136 D85EX-15 (1)