Komatsu — ADJUSTING BRAKE PEDAL

TESTING AND ADJUSTING ADJUSTING BRAKE PEDAL Adjusting at parking brake lever 1. Assembling and installing lever assembly 1) Assemble lever assembly (9) and adjust the operation of limit switch (10). a When assembling the lever assembly, disconnect the parking brake cable from the lever. When lever is raised: OFF, lowered: ON Operation stroke of limit switch: 3mm 2) Install lever assembly (9). 3. Checking brake oil pressure Check that the brake oil pressure is as follows when the parking brake lever is set in the FREE and ROCK positions. a For the method of measuring the brake oil pressure, see MEASURING POWER TRAIN OIL PRESSURE. LOCK position:0 FREE position: Specified pressure 2.

Adjusting length of parking brake cable 1) Connect parking brake cable (11) to the lever and valve and adjust dimensions f and g . Dimension f of cable: 88mm Dimension g of cable: 90mm 2) Operate parking brake lever (12) between the FREE and LOCK positions and adjust rod end (14) so that spool stroke h of brake valve (13) will be normal. Spool stroke h : 13.0mm 4. Checking limit switch Change the monitor panel to the monitoring dis- play mode and set the parking brake lever in the FREE and ROCK positions. Check that the limit switch signal is normal at this time. a For the operating method of the monitoring display mode, see “SPECIAL FUNCTIONS OF MONITOR PANEL (EMMS)”. Monitoring code:

40910 (Steering controller related switch input 1) 20-138 D85EX-15 (1)