Komatsu — EMERGENCY ESCAPE METHOD WHEN POWER TRAIN HAS TROUBLE

TESTING AND ADJUSTING EMERGENCY ESCAPE METHOD WHEN POWER TRAIN HAS TROUBLE EMERGENCY ESCAPE METHOD WHEN POWER TRAIN HAS TROUBLE a Since the male side of connector PL2 is kept disconnected, mask it with a vinyl sheet, etc. a Put switch assembly [1] in the cab through the cab window. a Devices used for emergency escape 1. Escape with switch box (Use H1) a If the machine cannot be moved because of a trouble in the electric system of the power train control unit (travel direction, gear speed, steering), escape according to the fol- lowing procedure. a The engine must be startable for the follow- ing procedure. If the engine cannot be started, see EMERGENCY ESCAPE WITH BRAKE RELEASING DEVICE.

1) Connect switch assembly [1] to wiring har- ness [2] of emergency escape device H1 . 3) Disconnect neutral safety relay ( NSF ) in the rear control box and connect pins [3] and [5] of the connector on the wiring harness side. a If the connector ( PL2 ) is disconnected, an model selection error is made and the neutral safety relay is not driven because of that error. The above work must be performed to avoid this problem. Set the all gear speed switches of switch assembly [1] in the OFF position and the direction switch in the P position to prevent the machine from starting suddenly. If the engine is started by this method, the neutral safety function does not work.

Accordingly, before starting the engine, set the parking brake lever in the LOCK position and set the PCCS lever in the full neutral position. Start the engine by this method only in an emergency. If the engine does not start in another case, be sure to carry out troubleshooting and repair the trou- ble. 2) Open the left fender inspection cover and connect wiring harness [2] to connectors PL1 (1) and PL2 (2). Connector PL1 (1): Connect to male side and female side. Connector PL2 (2): Connect to female side. D85EX-15 20-139 (1) Symbol Part No. Part name H 1 19M-06-32820 Switch assembly 17M-06-41530 Wiring harness 2 790-190-1600 Pump assembly 3 07235-10314 Elbow 07002-11823 O-ring