Komatsu — ADJUSTING CLEARANCE OF IDLER

TESTING AND ADJUSTING ADJUSTING CLEARANCE OF IDLER ADJUSTING CLEARANCE OF IDLER a If the lateral guide and vertical guide of the idler are so worn that the idler runs out or slants, adjust the clearance of the idler according to the following procedure. 2. Vertical adjustment 1) Measure clearance b , subtract 2 mm from it, and record the result (quantity of adjust- ment). Example: When clearance b is 5 mm The quantity of adjustment is 5 – 2 = 3 mm. 2) Loosen bolts (3) (4 pieces on inside and out- side) until the reaction force of the spring is lost. 3) Loosen bolt (1). Do not loosen it more than 3 turns, however. 4) Pull up vertical guide (4) with a bar, etc.

and pull out shim (5) by the quantity of adjust- ment obtained in 1) above. 5) Add shim (5) pulled out onto shim (6). (8 places in total on both sides, inside, and out- side) a The total number of shims (5) and (6) before adjustment must be the same as that after adjustment. Sorts of shim thickness: 1 mm, 2 mm 1. Lateral adjustment 1) Drive the machine 1 – 2 m on flat ground, and then measure clearance a between the track frame and guide plate (at 4 places on both sides, inside, and outside). 2) If clearance a is larger than 4 mm, loosen bolt (1) and reduce shim (2). Standard clearance a on each side: 0.5 – 1.0 mm Sorts of shim thickness: 0.5 mm, 1.0 mm 20-142 D85EX-15 (1)