TESTING AND ADJUSTING INSPECTING WEAR OF SPROCKET, TESTING AND ADJUSTING TRACK SHOE TENSION INSPECTING WEAR OF SPROCKET TESTING AND ADJUSTING TRACK SHOE TENSION a Make a copy of the “Full-scale drawing of sprocket tooth profile” on a transparent sheet and apply it to the sprocket directly to see if the sprocket is ser- viceable. Testing 1. Drive the machine slowly on a level place, then stop it. a Do not apply the brake when stopping. 2. Place straight steel bar (1) between the idler and front carrier roller and measure clearance a between the bottom of the steel bar and shoe grouser. Standard clearance a :
20 – 30mm Adjusting a If the track shoe tension is abnormal, adjust it according to the following procedure. 1. Remove cover (2). 2. When the tension is too high Loosen plug (3) to discharge the grease. Since the high-pressure grease may spout out, do not loosen the plug more than 1 turn. Plug: 59 – 88Nm {6 – 9kgm} 3. When tension is low Add grease through grease fitting (1). a If the track shoe is not tensed well, drive the machine forward and in reverse slowly. D85EX-15 20-143 (1)