Komatsu — TESTING AND ADJUSTING WORK EQUIPMENT AND HSS OIL PRESSURE

TESTING AND ADJUSTING TESTING AND ADJUSTING WORK EQUIPMENT AND HSS OIL PRESSURE 2. Measuring work equipment oil pressure and HSS oil pressure 1) Remove the main control valve cover. 2) Remove pump discharge oil pressure pickup plug (1) and LS oil pressure (load sensing pressure) pickup plug (2). HSS oil pressure i) Start the engine, set the parking brake lever in the free position, and press the brake pedal. Since the steering circuit will be relieved, keep pressing the brake pedal securely and keep your right foot on the decelerator pedal for safety until the work is finished. ii) Run the engine at high idling and steer to the right or left with the PCCS lever.

When the steering circuit is relieved, measure the oil pressure. iii) After finishing measurement, remove the measuring instrument and return the removed parts. a The unload pressure and relief pressure can be measured in the "Pm clinic auxil- iary mode" of the monitor panel. 3) Install nipple G2 and connect it to oil pres- sure gauge [1] of hydraulic tester G1 . a Use an oil pressure gauge which can mea- sure the following pressure. Work equipment oil pressure: 39.2 MPa {400 kg/cm 2 } HSS oil pressure: 58.8 MPa {600 kg/cm 2 } Work equipment oil pressure i) Start the engine and set the safety lock lever in the free position.

ii) Run the engine at high idling and operate the blade lever and ripper lever. When each cyl- inder is relieved at the stroke end and mea- sure the oil pressure. a When measuring the relief pressure of the blade lift cylinder, block the return oil hose. iii) After finishing measurement, remove the measuring instruments and return the removed parts. D85EX-15 20-145 (1)