TESTING AND ADJUSTING SPECIAL FUNCTIONS OF MONITOR PANEL (EMMS) Adjustment mode table and adjustment procedure Items marked with q in the Disassembly/Assembly column of the above table must be adjusted after the machine is assembled or any controller is replaced. (For the adjustment procedure, see “ADJUSTMENT AFTER REPLACEMENT OF CONTROLLER”.) a The numbers marked with a can be displayed in order by setting the information switch in the ">" or " position. 20-180 D85EX-15 (5) No. Code Adjustment item Related information Disassembly/ Assembly [1] 0001 INP TEL NO. Phone No.
input mode Figure/Symbol a[2] 0002 S/T S.CODE Steering and transmission controller specification set Code q a[3] 0004 BODY TYPE Machine specification set Code q a[4] 0005 BRAKE BASE Brake potentiometer zero point adjustment Voltage q a[5] 0007 ENG.FULL CH Engine deceleration-cut mode Speed [6] 0008 INJ->123456 Common rail reduced cylinder mode Speed a [7] 0009 PITCH SENS.
Pitch angle sensor initial set Voltage a [8] 0010 FAN 70%MODE Fan 70% speed mode Adjustment data a[10] 1005 FAN100%MODE Fan 100% speed mode Adjustment data [11] 1012 S/T N-SET Steering lever neutral set Voltage [12] 1013 S/T M.L-SET Steering lever left set Voltage [13] 1014 S/T M.R-SET Steering lever right set Voltage [14] 2222 HSS ADJUST HSS lever initial current set (HSS specification) Current [15] 9997 HI IDLE SET High idling limit mode Speed [16] 9998 SFT INHIBIT Gear speed limit mode Symbol