TESTING AND ADJUSTING SPECIAL FUNCTIONS OF MONITOR PANEL (EMMS) [ 1 ] 0001: Phone number input mode This code inputs or changes a phone number to be displayed simultaneously with when the user code is displayed. The lower part displays a phone number and symbols. Available characters: 0 1 2 3 4 5 6 7 8 9 : ; ? Instructions for use: By operating the information switch (5), shift up switch (6), and shift down switch (7), input a phone number and symbols. [ > ]: Moves the cursor rightward. [ Moves the cursor leftward. [UP]: Advance the numeric character or character (in the order of available characters). [DOWN]:
Reverse the numeric character or character (in the reverse order of available characters). a Sixteen digits of numeric characters are pro- vided. To avoid confusion, input symbols other than numeric characters at digits you will not use. a 0 (zero) is input at all places of the lower part before shipment from our factory. (No phone number is displayed under this condition.) a The setting is enabled even after ending this code. [ 2 ] 0002: Steering and transmission controller spec- ification set This code is used to initialize the specification codes recognized by the steering controller and the set values of the memory in the controller. The specification code is displayed on the lower line.
Adjustment method : 1) Set buzzer cancel switch (4) in the [ ] posi- tion and check that the caution buzzer sounds. 2) Check that the displayed specification code has changed from [4*4] to [444]. a If specification code [444] is not displayed, the controller wiring harness or the controller unit may be defective. a Even if this code is turned off, the setting is effective. D85EX-15 20-181 (1)